Mold is a major-league annoyance. It blackens the grout lines in your shower, tarnishes drywall, appears as black areas on siding, darkens decks, and grows on and rots wet wood all over. Even worse, it can be bad for your health. Mold releases tiny spores that trigger allergic reactions, runny noses and sneezing, in addition to annoying and even damaging odors. We'll cover how to remove mold, how to eliminate black mold, how to kill mold on wood and what kills mold in a few steps.
View this video to learn which surface areas you're better off removing and changing instead of attempting to clean:
If you have to get rid of mold concentrations or carry out any black mold removal covering more than a couple of square feet, we advise you take these safety measures:
Wear old clothing and shoes that you can wash or throw away after the clean-up work.
Use special N-95 or P-100 respirators, in addition to safety glasses and gloves.
Set an old box fan or an inexpensive new one in a window to aerate the space while working. Throw it out when you're done cleaning, because the spores are almost impossible to clean up off. Tape plywood or cardboard around the window openings so the spores can't blow back in.
Wrap and tape moldy carpets in 6-mm plastic, and double-bag mold-infested debris in trash bags for disposal.
To control air-borne spores, moisten moldy areas with a garden sprayer while you work.
Shut off your heating system and air conditioning system and cover ducts and doors to include spores.
Keep your wet/dry vacuum outside when you vacuum.
Cut stained or musty carpet and pads into 6x8-ft. areas with an utility knife.
Using a pump sprayer, mist the surfaces with water to control the spread of spores, and roll up the areas. Double-wrap them in 6-mm plastic and tape them with duct tape for disposal.
Pro tip: Use protective clothes and run an exhaust fan in the window.
Pry off baseboards and trim from polluted locations with a pry bar and block of wood.
Probe greatly stained or moisture-swollen walls utilizing a screwdriver to discover and open up wetness damage and surprise mold in the insulation and wall framing.
You have to open up the wall to get at the mold growing within. Since you require to fix the wall anyhow, don't be reluctant to cut the drywall back beyond the obvious damage to discover all the mold and let the wall dry.
To prevent cutting electrical wires, poke a hole through the damaged area and find the wires initially.
Switch off the power to the outlets before you cut.
Mist the Click for more info moldy drywall and insulation with the pump sprayer to avoid spreading out mold spores.
Double-bag musty product in sturdy plastic bags and tie them shut.
If te moisture damage has actually been neglected or gone undetected for long, you're most likely to discover rot.
Where possible, get rid of and replace soft, spongy studs and wall sheathing.
Where removal is tough, deal with the impacted locations with a wood preservative after cleaning the wood and allowing it to dry. Then double up decayed members with pressure-treated wood.